0

Welcome to our online store!   We’re adding new products daily, so check back often. We stock a huge selection of new and used parts in-store at all times, including both OEM and aftermarket options.

We specialize in Harley-Davidson parts, with thousands of new and used components spanning from 1903 right up to today. In addition, we carry an extensive range of British motorcycle parts, including Triumph, Norton, BSA, and more.

What you see online is just a small sample of what we have available. If you can’t find what you’re looking for—or aren’t exactly sure what you need—reach out to us by phone or email. We’ll do our best to source the right parts for you. If it exists, chances are we can get it.

Our online inventory includes both new and used parts, so please be sure to read item descriptions carefully and review all posted photos before purchasing.

If you need additional details or more photos, we’re more than happy to provide them—just reach out.

For shipping, please contact us if you have questions or special requirements. Online shipping estimates may vary from actual costs depending on the item, size, or destination. If something doesn’t look right, let us know and we’ll make sure it’s sorted out before checkout.

We also offer financing options to help make your build or repair more affordable—be sure to visit our financing page for details.

Have parts or motorcycles you no longer need? We buy new and used parts as well as complete motorcycles, offering fair value for quality items. Consignment is also available on select pieces.


Give us a call or send us a message—we’re here to help keep your bike on the road


Note: We do not clean used parts we make sure they are in working condition. Any parts with a stock photo mean it's new product unless otherwise stated.

Hardtail - Oil in Frame Twins- BSA Triumph Weld on Style Hardtail

C$399.99
In stock: 1 available
Product Details
Hardtail - Oil in Frame Twins- BSA Triumph Weld on Style Hardtail

Triumph / BSA - 71 Later


Instructions -

For Oil-In-Frame Triumph and BSA Twins.
Drain the oil and remove the oil cap.
Cut off the rear section of the frame; leave the swingarm in place.
Place the hardtail section in position using the swingarm as a guide. Align the inside of the the rear hardtail plates with the inside of the swingarm. (It may be necessary to trim off part of the extreme rear section of the swingarm.) Place a length of round stock in the axle slot of the hardtail. Do the same to the swingarm. Align the two rods by shifting the bottom of the hardtail from side to side until both rods are exactly level. The hardtail is now ready to be welded.

Be careful not to burn through the frame (oil tank) when welding.
A gusset can be fabricated and placed at the top of the hardtail after the top tubes are welded in place.
The hardtail uses the stock adjuster set up. The rear of the section may need to be flattened a bit to allow proper alignment of the adjuster.


Save this product for later
Share this product with your friends
Hardtail - Oil in Frame Twins- BSA Triumph Weld on Style Hardtail